One of the first things I read even before receiving my Printrbot was that one of the best methods of […]

One of the first things I read even before receiving my Printrbot was that one of the best methods of […]
Finally got a chance to install the longer 12in rods leftover from the Z rods I cut down to 24in, […]
After sitting overnight the initial soak of the acetone was looking good on the bits I cut off. I added […]
Was working today, assembling a part, it slips and lands on my hand, I yell, smack my pants to get […]
Feeling that the original print was a little short so set out to model an extension piece that will slide […]
Tired of my black or red prints getting pinkish brown tints because of my old slurry that was basically any […]
I decided I wanted to 3D Print a grenade launcher for my Spyder MRX, I’m mixed between using it for […]
check out my Google+ page as well https://plus.google.com/113777278617322369086 Google+
So my Hosting (iPage) decided to raise my fee every year to the point where I can no longer provide […]